#7138's Inlets & Outlets are TOO big (14mm).  11mm hose requires 12mm
Inlet/Outlets to properly seal when installed.

Jim Thompson
84 Westfalia 2.1 "Ole Putt"
oldvolkshome@earthlink.net
jim@karmannghia.com
http://www.oldvolkshome.com
***********************
----- Original Message -----
From: "Robert Lilley" <RClilleyjr@COX.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, July 30, 2004 12:49 PM
Subject: Re: Exactly which filter for pre-pump retrofit?: SUM FOUND ONE!!!

> Just remembered that CP Performance sells one for $9.95
>
>
>
> http://cbperformance.com/catalog.asp?ProductID=314
>
>
>
> Robert
>
>
>
>   _____
>
> From: Phillips, Andrew [mailto:phillips@isgs.uiuc.edu]
> Sent: Friday, July 30, 2004 12:01 PM
> To: Robert Lilley
> Subject: RE: Exactly which filter for pre-pump retrofit?: SUM
>
>
>
> Did that, been there. None of them fit the bill. Even looked at tractor
> filters. There was one high-performance metal one that cost about $30.
>
>
>
> Thanks, though,
>
> Drew
>
>
>
>
>
> -----Original Message-----
> From: Robert Lilley [mailto:RClilleyjr@cox.net]
> Sent: Friday, July 30, 2004 1:38 PM
> To: Phillips, Andrew
> Cc: 'Vanagon Mailing List'
> Subject: Exactly which filter for pre-pump retrofit?: SUM
>
>
>
> Why not just go down to a local Pep Boys, AutoZone, etc. and look at the
> wall of fuel filters and find one that has a large enough inlet and
outlet?
> Then you can just post the part number.  They have a number of metal
> filters.
>
>
>
> Robert