Jason,

The Blue LEDs required more current than the red LEDs. I am not familiar
with the circuit in the refer LED, but many times there is a current
limiting resistor. By changing this resistor to a lower value, the blue
LED will work. Also, some blue (white, etc) LEDs require a slightly higher
forward voltage, as well.

Note that many blue LED flashlights have two 1.5 V batteries, or one 3
Volt lithium.

Jon

On Wed, 4 Aug 2004, Jason Willenbrock wrote:

> hey all,
> my LED green light to indicate my propane pilot is burning is very dim at
> best. so i went to radio shack today to find a replacement.  i found a cool
> blue led that looks identical to the green stcok bulb.  however when i
> installed it the LED replcemetn would not work.  i then reinstalled the
> green buldb and tyhat still works.  i tried a second blue LED (i bought 2
> just incase...) and that would not work either.  what is the right type of
> bulb to work here?  it seems like a low voltage circuit board and most any
> bulbs should work.  does anyone have better info,  i really liked the blue
> bulb and would like to go with that.  the bulb i purchased at radio shack is
> a high out put 5mm infrared LED, output is 16mW min.  forward voltage is
> 1.2v, forward current is 100mA.  are these not correct for the westy sicuit
> board?
> TIA for any inout
> jason
> 87 syncro westy
>
> _________________________________________________________________
> Discover the best of the best at MSN Luxury Living. http://lexus.msn.com/
>