I'm guessing I gal for the outside & 1 for the inside.
The problem I see, is that the doors & hatch are off,
and I'm thinking of painting them separate.
I worry, though, that differences in humidity, temperature, etc.
will show.
So, I guess I will just paint the door jambs first,
then install doors & hatch, then shoot the whole thing.
I also have to install fiberglass bumpers & trim.
And install electric door locks & windows,
where manual were.
I hope I can safely do this after painting?
thanks,
John C.
SLC, UT...

re-think your quantities.  Base-coat clear-coat does not take that much
color.  Maybe 3/4- 1 gal.  You thin with activator witch, depending
on the paint, may double the volume. Same with the sealer and clears.

            Eric                   86-VW4x4

> I've been quoted anywhere from $400 to $700 @ gallon, for the color.
> This seems ridiculous to me!

you think that's bad? go check on some of that 3M chameleon stuff!! :)

> Anyway, It looks to me like about two gallons each?
> Any experience from you painters out there on this?

no way to figure square foot coverage per gallon? then you could
better guesstimate.

good luck!
joel