

| Subject: | Re: Power steering rack to standard rack |
| From: | Max Wellhouse |
| Date: | Mon, 11 Oct 2004 11:23:17 -0500 |
I think Ken Wilfy has done this swap to manual and there is an issue with the couple to the steering wheel shaft if I remember correctly. I will eventually do this swap on my van as I've been going for 3 years with no pump and eventually that lack of PS fluid is going to lock something up in there. I don't mind the extra"exercise". Max t 11:03 AM 10/11/2004, Christopher Brooks wrote: >l definitely agree with Dennis. My power steering rack started going bad >about this time last year, dropping the reservoir level from max to min in a >couple days.. Then by Feb... it needed to be filled every day. I rolled >the dice >and bought a used rack from a guy who was parting a van out for $90 and I have >put on about 3400 miles since then with no problems. > >I have never seen a standard rack installed on a Power steering van, but I >would imagine that it would take quite a bit of elbow grease to turn the >steering wheel. > >Only took about 30 minutes to change out the rack, and that was with clean >up, too. > >Chris > >In a message dated 10/11/2004 11:56:52 AM Eastern Daylight Time, >dhaynes@OPTONLINE.NET writes: >If you disconnect the lines at the rack to allow all the fluid to drain out, >there is little difference. The non PS vans use a larger steering wheel and >different spindles to reduce the effort. Replace the rack and you should >be good >for another 100K. > >Dennis
Have something to add on this topic today? Revive this thread in the forum »