Maybe the pin the pushes down on the throwout lever from the slave
cylinder isn't seater properly.

Jim

On Nov 7, 2004, at 9:31 PM, Ryan Dawson wrote:

> Hi guys,
>
> I have a question about my clutch.  I just had the tranny dropped to
> install a new clutch.  After I put the tranny back in and tested the
> clutch pedal, it felt very loose with little resistance.  While
> removing the tranny I didn't brake or remove any of the lines going to
> the clutch cylinder.  So, I'm confused as to why my clutch won't
> engage, or disengage.  The shifter is fine and I can shift into all
> four gears, so I know that I installed the clutch correctly.
>
> Any ideas?  The van is an '84 Westfalia with an 091 tranny in it.  I
> have just completely my Subaru conversion and went with an upgraded
> Luk clutch kit with a new disc, pressure plate, and release bearing.
>
> I'm stumped, so any assistance is greatly appreciated.
>
> Thanks,
> Ryan
>
>
>
> ---------------------------------
> Post your free ad now! Yahoo! Canada Personals
>