Personally I would try other more simple methods before cutting the door.

Why not try first to hang a piece of heavy plastic that you can lift to
access your stuff. Much like they have in the supermarket coolers. You can
even cut a couple of vertical slits in the plastic to allow you to reach in.
Weight it at the bottom with plastic doweling cut from a coat hanger. A
little duct tape at the top to glue it into place, or some of those 1 inch
square Velcro items you buy at a yardage shop to keep plastic in place?

Personally I would not mess with cutting the door.

Good luck with your efforts.

William

>I have a fridge mod in mind and wanted to know if anyone has experience
> with similar. I would like to not have to OPEN the door when I want to
> switch between modes (12V, LP Gas, AC). This is a huge waste of the
> precious cool air inside. So, here is my idea:
>
> Could you cut off the upper portion of the door (what, maybe the top 2
> inches?) that covers the controls, leaving the bottom portion as it is
> installed. Then, affix this portion back to the lower with 2 small
> hinges on the outside, so that it swings out and down. Last, put a
> magnetic latch at the top to secure this upper portion closed when not
> accessing the controls.
>
> Anyone ever attempted this or seen it done?
>
> Thanks.
>
> 83.5 Westy
>