OK,

As I understand it, the heat/air levers themselves - that part sticking
through the slot in the dash, -  is made with that little flattened
plastic piece that serves as  a finger piece or knob, permanently
attached and that little plastic piece is not removable. If it is
removed then basically the lever is no longer whole or functional. The
lever itself is made to detach behind the slotted dash plate somewhere
and to simply slide out the slot, in the event of need for repair or
replacement. Have I got this right??

What is the lever made of?

How difficult to remove and replace?

Mine are stiff and don't move easily. Without knobs they are actually
almost impossible to slide left and right because they hurt my fingers.

If my assumptions are correct, since the knobs have been removed, then
there is nothing to do but get replacement levers with knobs and install
them. Correct???

TIA,

Regards,

John Rodgers
88 GL Driver

John Rodgers wrote:

> The heat/cooling lever knobs were removed to allow for a repair. Now
> they won't stay on. Any ideas as to how to get them to stay put???
>
> Thanks,
>
> John Rodgers
> 88 GL Driver
>
>