Was doing some measurements to put in the 1/4 inch oak paneling into the cab
ceiling and ran into an interesting problem.

There is a curve that seems to be sharper than 1/4 inch will handle.

A trick I have seen is to take a router and put some small grooves down the
length of the part to be curved.

Would this work for the standard quarter inch ply?  Trying to avoid wasting
a sheet.
(prices have gone up again on sheet)

����������������������������������������
jimt
Planned insanity is best.
Remember that sanity is optional.
http://www.tactical-bus.info (tech info)
http://www.westydriver.com