Do you have a scrap to experiment with? Instead of a router use a utility
knife with a new blade and set the blade depth to 1/8 inch. William

Was doing some measurements to put in the 1/4 inch oak paneling into the cab
ceiling and ran into an interesting problem.

There is a curve that seems to be sharper than 1/4 inch will handle.

A trick I have seen is to take a router and put some small grooves down the
length of the part to be curved.

Would this work for the standard quarter inch ply?  Trying to avoid wasting
a sheet.
(prices have gone up again on sheet)

........................................
jimt
Planned insanity is best.
Remember that sanity is optional.
http://www.tactical-bus.info (tech info)
http://www.westydriver.com