

| Subject: | Re: Vanagondalism |
| From: | Randy Bergum |
| Date: | Wed, 26 Jan 2005 10:32:59 -0800 |
I've always wondered about that setup - 'twould be neat to have a permanent metal arrangement to replace the plastic, smog-failing, mother-fathers. Stainless steel would be best - no corrosion, and strong enough to take gravel strikes. Just make sure it doesn't rub on any frame members and wear a hole in it. Don't know about installation - do you have to bend the plastic filler a little to install it? Randy Bergum 1990 Carat > [Original Message] > From: jimt <camper@TACTICAL-BUS.INFO> > To: <vanagon@GERRY.VANAGON.COM> > Date: 1/26/2005 10:10:55 AM > Subject: Re: Vanagondalism > > On 1/26/05 10:45 AM, "RP" <personalbsd@YAHOO.COM> wrote: > > > I have been getting lousy gas mileage on the last > > tankful, and went to fill up today. I noticed that my > > locking gas cap was busted and sitting in the opening. > > So I figured this explained my lousy gas mileage, > > someone must have siphoned my gas. > > THEN when I went to fill it up, gas starting spilling > > out all over the place. > > Someone has cut (nice clean cut) my fuel filler neck > > hose. > > So I know I need to replace my gas cap and fuel filler > > neck hose, but what else might there be in need of > > replacing, assuming that nothing else was vandalised? > > > > Rick > > Sacramento > > 91 westy > > > > > > ===== > > Rick > Look up under there for the vent hoses and see if they got snipped as well. > > Also there was a similar incident here a while back that was caught on a > security camera (not on a vanagon but a chevy or ford commercial) the camera > caught the duo ripping off the gas cap to siphon. Couldn�t siphon so went > under and cut the filler hose or fuel line. Couldn�t tell which and they > didn�t say which it was. > > ���������������������������������������� > jimt > Planned insanity is best. > Remember that sanity is optional. > http://www.tactical-bus.info (tech info) > http://www.westydriver.com
Have something to add on this topic today? Revive this thread in the forum »