The power for the ignition and the ECU goes from the ignition switch, into a connector at the fuse box, then out through another connector to the rear. These connections occasionally burn at the pins. Don't know the pins or connector numbers, I'm at work. Reach behind the fuse box and do the pull tug thing and if it works, that is the problem. If you have the Bentley book you can look up the connection points. As this circuit is not fused, find the 2 wires and jump them together.

Dennis

----- Original Message -----
From: Doug <vanagons@COX.NET>
Date: Sunday, February 6, 2005 3:35 pm
Subject: Re: I need advice/help - Elecrical

> Volks,
> Could use any advice on my current problem (among others!).
> For some reason, I'm not getting power to the ECU.
> '88 Carat, Digifant,  with some jury-rigging done to the wiring in the
> engine compartment. Only have Start signal from ECU. no Pwr.
> According to the Bentley, power should come from the ignition switch.
> Swapped out ign. switch with a known good one, no good.
> All fuses in box are OK, and wiring up front looks good.
> Installed an ECU set up with DigiTool, no power-up.
> Starter turns over, but no fuel pump!
> Any advice appreciated!
> Thanks,
> Doug in CT
>