

| Subject: | Re: Digijet O2 Sensor Wiring Issue |
| From: | joe brown |
| Date: | Sun, 13 Mar 2005 12:17:09 -0800 |
When I tried to set my DigiJet to .5 with the 02 sensor disconnected, I also had no power just off of idle. It would also cause the idle speed to surge. I set mine richer until it doesn't have the flat spot off of idle. I also monitor my 02 readings while driving whith the 'digitool' and the Ecu appears to handle everything fine when the 02 sensor is reconnected. Chuck Mathis <cmathis@HOUSTON.RR.COM> wrote:'85, 1.9l Digijet, Automatic. While trying to get Roland ready for the state emissions check I replaced the O2 sensor. I tried setting the AFM per the instructions posted a few weeks ago and all the readings were good - O2 staying between .4 and .5 at idle reading with a multi-meter with the sensor disconnected from the system. The engine ran like a champ until I plugged the sensor back in and tried to zip off to the test station -- suddenly it has no power off idle and the O2 readings on my digitool are going negative at the same time. Figuring it must be a short in the fat green wire i disconnected the ECU and pulled the cover off the plug. With one probe in pin 5 and the other in the female connector on the wire it reads 0 resistance and no amount of bending, twisting and turning the green wire changes that - seems like that should cause the resistance to increase if there is a short. The shielding checks out with a big fat 0 and between the shielding and the conductor I get an infinite reading probing both ends in various combinations. There is a white wire spliced to the green that runs to pin 6. With the probe in pin 6 and the green female I get infinite resistance. Same with the probes in 5 and 6, 5 and the splice, and 6 and the splice. From all this poking around I believe that the shielded green wire is just fine and the white wire to pin 6 splice is bad. Am I right or do I need more beer? (I'll have a beer anyway) What is the best way to fix this? I'm thinking remove the insulation from the splice, solder it then wrap it up good. Chuck '85 Wolfsburg Westy - 'Roland the Road Buffalo' --------------------------------- Do you Yahoo!? Make Yahoo! your home page
Have something to add on this topic today? Revive this thread in the forum »