The right rear axle nut appeared "loose" after removing cotter pin, although
it's not actually loose...but
did move 1 inch. back and forth BY HAND?  I removed it too easily......

Obviously...not tightened enough over last 5 yrs.....

So......I cannot "mark" because last point was not tight enough.

So.....Here's my plan...tell me better method....

Retighten using 5-6 ft. bar, I weigh #230 at 2.5 - 3 ft. out should that
work?

Thanks for any ideas

Larry
Georgia

PS.  I've seen the math formula (using your body weight....anyone have
that)!

PSS.  I'm assuming this axle nut tight is critical to long life of bearing,
correct?

----- Original Message -----
From: "Roger Sisler" <rogersisler2000@YAHOO.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, May 06, 2005 11:12 AM
Subject: Re: 1985 Vanagon 2 WD - rear axle nut

> Whatever method you use, think ahead ,and remember that you will need to
> accurately retorque da nut. File a small match mark on the nut and bering
> housing so you can tell when yu have retightened enough.Just one of
several
> ways to do this.I once used  a 10 foot long  cheater pipe to remove the
> nut.A "nut whacker" can be had from many vendors for about $5.This is a
> piece of cast iorn that fits over the nut. A breaker bar is attached and a
> hammer"whacks" the cast iorn. This is done while while downward pressure
is
> placed on the breaker bar. Works good.
>