I have Mobil 1 in the crankcase and a Mahle filter.

I think I need to reserve judgement until I've driven
the van a while.  I've run it less than an hour since
I put it in, and it's been sitting ~6 months with me,
and was in storage when I got it.

Oil pressure seems good, ~8 psi at idle with a hot
engine, if you believe my gauge.  (I know it was
hot because the thermostat was stuck closed!)  I
checked the oil pressure right away after the
engine was in because I don't know its history.

I had tons of trouble setting the valves initially
and the thing clattered like a beetle when I first
started it.

It never ends, does it?  I know, just get a Subaru
or a Diesel...

Sigh,

--tabe

>Date:    Tue, 7 Jun 2005 07:53:44 -0700
>From:    Shawn Wright <swright@ZUIKO.SLS.BC.CA>
>Subject: Re: Hydraulic Lifter Week
>
>Tabe,
>
>What oil are you running? The one time I ran regular dino oil (Castrol 20w50) I got
>terrible lifter noise until the engine was fully hot, sometimes taking 20 minutes or
>more. I went back to Mobil 1 15w50 or Amsoil 15w40 and the lifter noise was gone. I
>ran it this way 8 years, and even if the van sat for 3-4 months, lifter noise never
>lasted more than a few seconds at startup with synthetic. I used to just change the oil
>and filter once per year, since I only drove it about 10k per year.
>Sounds like you should check your oil pressure for sure though...
>
>On 7 Jun 2005 at 6:16, Dennis Haynes <dhaynes@OPTONLINE.NET> wrote:
>
> Lifter click at idle is due to a bad lifter (stuck ball check) or
> insufficient oil pressure.
>
> Dennis

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com