Hi,

Well personally I removed my old lines first and brought the ends in as a
sample.  The ends are metric, and my new hose consists of the following:

Hose : 

I used SR17-06  (3000 psi)

Fittings : 

A50A43-05-06 (qty 2, w/ one at each end of hose)
110000-06 (qty 2, w/ one at each end of hose)

The technician put these into a machine that sealed both parts together and
onto the hose.

Also it was a bit difficult to remove the old lines so I used some WD40 w/ a
good wrench and it loosened it right up.

If you have any more questions please do not hesitate.

Best regards,
Shawn

-----Original Message-----
From: dylan friedman [mailto:insyncro@yahoo.com] 
Sent: June 23, 2005 8:39 AM
To: Shawn Luft
Subject: Re: Power Steering Hose Fabrication

Shawn,
Can you tell me what the size of the ends are that
were used or a company & part number from them.  I
have a local shop that can do the same.  Just need to
know which end to use.

Thanks.

dylan

--- Shawn Luft <shawnagan@SYMPATICO.CA> wrote:

> For info
> 
>  
> 
> I found a local hydraulics shop to make two (2)
> replacement Power Steering
> Hoses.  The total cost was 60$USD / 75$CAN and it
> took about 30 mins.
> 
>  
> 
> If anyone is in Quebec then you can get a hose made
> up at Hebdraulique (w/ 6
> locations).  
> 
>  
> 
> Best regards,
> 
> Shawn
> 
>  
> 
>  
> 

Dylan Friedman

insyncro.com  (in the works)
insyncro@yahoo.com
insyncro@hotmail.com

91 Syncro Westy GL
91 Syncro L
90 Carat (for sale)
89 Wolfsburg GL

87 Syncro GL X 2
86 Syncro GL

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com