

| Subject: | Re: interesting lifter thinking?? 1.9L still a problem child (update) |
| From: | Stan Wilder |
| Date: | Mon, 12 Sep 2005 20:44:39 -0500 |
Jonce give it up! Check the archives the lifter problem has to be either one or #3 on the most common Vanagon problems. Lets see, Leaky heads #1, Dual batteries #2, Tires #4 and lifter clatter #3. It's simply .006 like Bob Donalds says or one turn down like I say or anywhere in between that works for you. Stan Wilder Engine Ceramics 214-352-4931 www.engineceramics.com ----- Original Message ----- From: "Jonce Fancher" <streetbugs@WHISPLLC.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, September 12, 2005 7:11 PM Subject: Re: interesting lifter thinking?? 1.9L still a problem child (update) > Im still in experimental stages but i really think that as long as you have some preload on a hyd lifter it should be fine but 2 full turns seems a bit much even > for bentley. i will probably just take out the slop in the 2 adjusted lifters and make them just lightly push on the valve. as usual do a quick run around town > then check compression to see if it is up or gone. if gone i would have lost power on the short drive and the compression would be in the toilet. i really wont > get a chance to dink with this till the weekend at this rate. also there is a vw show in toledo on sunday that im planning on going to so im probably going to > let the van sit till i get a chance to mess with. i will post my findings under interesting lifter thinking as i go. c-ya Jonce > > >This is an issue sure to cause debate. I must tell you that I once set my > >lifters per the Bentley(lash +2 turns)and got no compression. The valves > >remained open even when "closed" and this collapsed 2 of the lifters for > >good.The lifters were gunked up before hand, but I believe this wont be > >healthy for even new lifters.The best I can figure out is that Bentley ment > >the settings to be lash +.2 turns.However I am certin this will not be > >agreed with.What I settled on , and what works fine for me is lash + 1/4 > >turn.I think this sets the lifters at the mid range of their travel.Good > >luck in this prosess, Roger > > > > Jonce Fancher > > 57 Single Cab > 66 Sunroof Bug > 66 Variant Squareback > 71 Sunroof Bus > 75 911S Sunroof > 84 Vanagon "Godfried" > 85 Vanagon Westi > 2003 10 Passenger Sprinter > > Fancher's Upholstery Inc. - www.fanchers.com > Not-A-VW Club- http://mywebpages.comcast.net/jaransont3/notavwclub/
Have something to add on this topic today? Revive this thread in the forum »