A quick disconnect for the wiring harness on a splittie?  Wow, that PO
must've been really bored or really lazy.  How many wires are on a splittie
engine... 5?  Three for the generator, one for the coil, one for OP switch.

Back in the early '80s when I was turning wrenches at a VW shop we would
fight for the engine R&R's on splitties.  We could do a clutch in about 1.5
hours.  Good money...

A Vanagon WBX'er engine R&R shouldn't take longer than 3.5 hours for anyone
who's done a few (add an hour if your doing the job in your driveway).

Cheers,

Jeff

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM]On Behalf
Of Stan Wilder
Sent: Wednesday, October 26, 2005 7:40 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: in the year 2015......

I had a walkthrough split, just by chance.
I had a big case of the dreads when I needed to put a clutch in it but once
I got started I found that the PO had installed a quick disconnect plug on
the wiring harness and then there was just the one fuel line to deal with.
The whole engine came backwards after removal of the rear-most lower body
panel. The R & R only took about two hours since I didn't need to pull the
tranny.
That's a definite upside to the removal of a Vanagon engine at about 12
hours for an R &R.

Stan Wilder
Engine Ceramics
214-352-4931
www.engineceramics.com

----- Original Message -----
From: "Andrew Grebneff" <andrew.grebneff@STONEBOW.OTAGO.AC.NZ>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, October 25, 2005 11:14 PM
Subject: Re: in the year 2015......

> >  >> The down sides to the Bay and Split window are the absence of a big
hole
> >>>  over the engine for easy access.
> >>
> >>  The 1600-powered Bays had no engine hatch at all!
> >
> >Yeah, & the worst hack in Splitdom, besides the wheel wells being cut
out,
>
> Ugh.
>
> >is to cut in a hatch over the engine to access the AC engine? I've seen
> >restos where they have patched in the hole to make it stock. Nope,
thinking
> >more, the bulkhead removal to make a walk thru is the worst!
>
> So why doidn't they look for a walkthrough Split? Hard to find,
> maybe... then, not all Bays were walkthrough either.
>
> >Tom-don't need no access panel to work on a upright engine, just need 4'
> >long arms.
>
> Dead right! EASY to work on. But I do have long arms...
> --
> Andrew Grebneff
> Dunedin
> New Zealand
> Fossil preparator
> <andrew.grebneff@stonebow.otago.ac.nz>
> Seashell, Macintosh, VW/Toyota van nut
>
> HUMANITY: THE ULTIMATE VON NEUMANN MACHINE
>
> DEMOCRACY: RULE BY THE LOWEST COMMON DENOMINATOR