I am currently running ET 45 5x112 Audi 5000 alloys, and  the only problem that I had was finding long enough bolts for the front, because of the approx. 10mm spacer that needed to be installed. I found nice long studs for the rear, and redrilled the wheel hubs to accept the larger splining. But the rear did not need the spacers, only the front. I figured out a trick, too, for reinstalling the fronts. I keep two pieces of wooden dowel, sized just large enough to fit in the bolt holes of the front rotors. This keeps the spacers and wheels mostly in place over the holes while I start the bolts! After I get the first two bolts in place, the dowels can be removed. Saves lots of frustration.
  Oh, and another thing to watch out for - the center hole size! The front hubs on a 2WD Vanagon need about a 66mm hole for clearance of the dustcap for the bearings. I also had to have the holes in these Audi wheels opened up so they would fit on the front.

Mark C <obeechi@RUNBOX.COM> wrote:
  hey, what do you think of the ET 45 15x7 spoke wheels???

they're calling them vanagon wheels, but wasn't vanagon ET30???

How do you put a ET45 on??

Were these really eurovan wheels??

Can they handle the weight??

Has anyone put these on???

Evan Mac Donald

1984 Wolfburg
1985 GL 7 Pass.
1991 Carat Weekender
1972 Chevy P/U
1993 Bonneville