Hi Mike

experiments with flushing & sea-foam seem easier to do first, but if
disassambly is needed is there a simple way to tell if the shaft is/was
seated?  There's measurement 'a' of 10mm shown in Bentley -- is measurement
the only way to tell?  The TC mated up with the

During reassembly there was no resistence to fitting the trans back on the
engine, at least, none noticable.  And as mentioned before, the TC was wired
in place, with wires removed only at the last moment before bolting.

Al

On 12/18/05, Mike Collum <collum@verizon.net> wrote:
>
> Was the long shaft that turns the pump put back in and properly seated?
>
> Mike
>
>