

| Subject: | Brake Light Switch Procedure (was Anyone Interested) |
| From: | honemastert |
| Date: | Tue, 3 Jan 2006 10:56:43 -0700 |
>> Re: Brake Light Switch.. >> Looks easy enough, but nothing in Bentley tells you how to do it or what = >> not to do in the process. John, (search the Vanagon.com archives.. I found the procedure there) Which one? front, back or both? In my case, only one was leaking, pretty quick and painless, if you do it right, you dont even have to re-bleed the brakes.. (have to be quick however!) see below: ================ Below are some basic instructions for doing the job: Disconnect the battery: You will be working without the dash and with exposed "hot" terminals so it is best to disconnect the ground connection. To do this move the passenger seat forward, remove the plate under the rear of the seat protecting the battery and loosed the ground connection. Pull the ground wire off the terminal and fasten it so that it does not flip back and touch the battery terminal again. Instrument cluster removal: Pull the instrument panel off and remove all the wiring. There are 4 Phillips #2 screws holding the plastic tab of the instrument cluster. Be careful, these tabs can get brittle with age. They can break and shatter. Wiggle you hand behind the speedometer and unclip the spedo cable. Just squeeze the connector and it will come out. Next pull out the switches by pressing the tabs to release them from the cluster. The cluster should lift out and remove the big wire connector plug. This will provide you room to get under the dash board. Put the cluster in a safe place that you will not sit or lay other components on. Prime the switch with brake fluid (so you dont introduce more air into the system) Dont let this stuff get on anything! (esp paint.. will eat right through it!) I only had to do the one in the photo, so I started unscrewing after removing the wire. Once I got to finger tightness, I positioned the other switch with my free hand, and pulled one out, while simultaneously stuffing the new one in its place. Do it quick, and you'll be okay.. hesitate, and it's time to bleed the brakes. hope this helps..! good luck, -tim
Have something to add on this topic today? Revive this thread in the forum »