I need some feedback and / or advice please. Just installed these H&R
springs on a customer's 2WD Westy-Tiico, lowering the van a good 2
inches [at his request, not my choice]. The front springs look very much
like the original VW ones except shorter. The rears, on the other hand,
are shaped differently on each end than the OEM ones, and do not really
fit into either the upper or lower insulators properly. The rears are
also compressed at rest to a point where the coils are all against one
another except for the very last one-one and a half. Rides 'ok', but at
almost every sharp turn or going into the driveway the rears go 'KLUNK'
once, sometimes a smaller clunk after. Very annoying, I'll tell you.
So...has anyone else here installed these, and how does this experience
compare with yours? Am I missing some key 'extra part' here? I can't
give the customer his van back with noises like this! Thanks for any input!

Karl Mullendore
Westy Ventures