> Sorry, I wasn't clear enough. The bracket I moved is the one screwed to
> the bottom side of the table. Moving it closer to one end gives the
> table a larger arc to swing in. This lets it move closer to the bed and
> also allows the other short edge to fit snug against the side panel and
> right behind the driver's seat.

Is this in a full westy?  It sits above the sink/stove unit?

Hmmmm,

Tom

 It also doesn't rattle since the one
> edge is pushed tight against the side wall before the adjustments knobs
> are tightened.
>
> Mark
>
>
> bueses wrote:
>
>>> I am talking about the full camper front table. It mounts to the
>>> driver's side front seat box corner, not the side wall. It pivots around
>>> on it's curved leg. I moved the underside table bracket position so the
>>> table stows right behind the driver's seat, still in the horizontal
>>> position. It can be used in that position or swung around till it is
>>> closer to the bed/seat. Of course this is all without a middle seat
>>> installed.
>>>
>>> Mark
>>>
>>>
>>
>> Any pics of how this works Mark?  Where is the corner bracket moved to on
>> the pedestal?
>>
>> Inquiring minds need to know.
>>
>> Tom
>>
>>
>>
>>
>>