In a message dated 2/24/06 2:04:17 PM Eastern Standard Time, inua@CHARTER.NET
writes:

> Subject says it all.
>
> I must replace my levers. but how the heck do you do that?? I have new
> ones, but I'm mystified as to how to get to them for r&r.
>
> Any suggestions will be appreciated.
>
>

i use needlenose pliers...  be CAREFUL not to catch the part of the lever
that slides over the metal tab on the climate control faceplate - otherwise
you'll crack the faceplate too..  i usually use a thin flathead to hold it down
while im pulling w/ the needlenose pliers...
BTW - use alittle grease on the metal tabs before you put the new ones
on...so they'll be easier to remove next time..

chris