Jonathan;

I found it.

www.holepro.com.

Very nice, very expensive for a hole saw. I have need to saw out a
bunch of round ends to tack into cardboard tubing, something like this
will do the trick. However, after looking at your post last night, I
decided to settle for the $7.00 version like that one! I'll see how it
works.

I sawed through the metal in the engine compartment of my diesel easily
with a big old bi-metal craftsman hole saw. Anyone looking to saw holes
in metal should look into those. Use with a little oil.

Jim

On Mar 11, 2006, at 11:30 AM, Jonathan Farrugia wrote:

> Jim
>
> it should be okay to cut wood i would think.  i bent the heck out of
> one of these a few years back trying to cut out some sheet metal slugs
> on a mill.  even going really slow and light on the down pressure
> caused the arm to bend :(.  one with two cutters is probably the way
> to go to distribute the load better.  i would say look in the mcmaster
> carr catalog you might find it there.
>
> http://www.mcmaster.com/
>
> jonathan
>
> On Sat, 11 Mar 2006, Jim Felder wrote:
>
>> Jonathan,
>> This is similar to the one I saw on this list a while back, except
>> that the one I'm looking for has two cutters on the beam that work
>> opposite each other to distribute the load. Seems like it cost about
>> $80. I am wanting to use it to cut wood.
>>
>> Thanks,
>>
>> Jim
>>
>>
>> On Mar 10, 2006, at 10:21 PM, Jonathan Farrugia wrote:
>>
>>> Jim
>>> is this the type of thing you are talking about:
>>> http://www.acehardware.com/sm-general-and-reg-hole-cutter--pi
>>> -1292919.html
>>> what is it that you want to cut a hole in?
>>> jonathan
>>> On Fri, 10 Mar 2006, Jim Felder wrote:
>>>> Some months back, someone provided a link to what looked like a very
>>>> sophisticated hole drill that had a bar with two cutters on it that
>>>> could be adjusted in tandem to cut a wide variety of radii.
>>>> Anyone have that again?
>>>> Thanks,
>>>> Jim
>>
>>
>>
>