

| Subject: | Re: gowesty aux battery problems |
| From: | Aaron Pearson |
| Date: | Sat, 8 Apr 2006 17:47:41 -0500 |
note that the int lights, cig lighter, and stereo were all operating fine previously, and were not drawing the battery down at all. maybe, when installing the antenna, i hurt the stereo wiring harness, and made a short? i'll check this. i triple checked the wiring diagram for the under-seat relay, but maybe it's not the right one, and the wiring doesn't work the same? gaaaah! aaron '87 syncro westy ej22 >From: Aaron Pearson <aarondpearson@HOTMAIL.COM> >Reply-To: Aaron Pearson <aarondpearson@HOTMAIL.COM> >To: vanagon@GERRY.VANAGON.COM >Subject: gowesty aux battery problems >Date: Sat, 8 Apr 2006 17:38:44 -0500 > >last weekend, i: > >pulled the fridge, cleaned it, and installed gowesty's increased airflow >starter kit >added gowesty's bright light relays, and put in new brighter bulbs >replaced the antenna >put in gowesty's aux battery kit > >everything worked fine, i drove it a couple times, no problem. now it is >clear that there is some load on my aux battery. i pulled the battery, >checked all my new wiring, and confirmed that the aux battery was connected >to the fridge/sink, cig lighter, int lights, and stereo. with all of those >things turned off, and the fridge/sink cord unplugged, my aux battery >voltage was dropping. i lost a 1/3 volt in 5 minutes. there's a 30amp >breaker in gowesty's kit, that remained untripped. when the van is on, all >the aux connections work fine, the aux battery charges fine. > >understand that the only things tapped into the aux battery are the things >i >listed. > >one thing i changed was i used a wire nut (like for installing light >fixtures in your house) instead of the peculiar four-socket plastic >connector. this is to connect the aux battery to the freshly clipped leads >for int lights, stereo and cig lighter. i couldn't get the wires into the >plastic connector without destroying them, and figured if the nut is good >for household 110, it must be okay for 12v. > >obviously, i'm not an automotive electrician, but i know how to strip and >crimp and run a dmm. > >any thoughts??? > >aaron >'87 syncro westy ej22 > >_________________________________________________________________ >FREE pop-up blocking with the new MSN Toolbar � get it now! >http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/ _________________________________________________________________ FREE pop-up blocking with the new MSN Toolbar � get it now! http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/
Have something to add on this topic today? Revive this thread in the forum »