Dennis, as so often is the case, had it right on. I did the 2nd
option, of adjusting the linkage rod one spline. The list comes
through again.

On May 2, 2006, at 6:54 AM, Dennis Haynes wrote:

> First attempt, loosen the shifter bracket on the trans, push
> towards the
> trans and tighten. This usually helps. If not, then you need to
> turn the
> rear linkage rod one spline counter clockwise, (facing front). Just
> loosen the clamp, using vice grips, hold front rod while turning rear
> unit you hear a faint click, tighten clamp and you should be set.