

| Subject: | Re: maybe too much information is worse... |
| From: | Dennis Haynes |
| Date: | Mon, 15 May 2006 07:51:27 -0400 |
Where is the oil temp sensor located? Is it really seeing oil temp or case and some other temps? I would be concerned about the oil pressure though. 28 psi ( 2 Bar) at 4,000 rpm is a minimum. a a healthy engine should be able to maintain almost 10 psi/1,000 rpm except under extreme conditions. Dennis > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On > Behalf Of > John Bange > Sent: May 14, 2006 17:50 > To: vanagon@GERRY.VANAGON.COM > Subject: maybe too much information is worse... > > Drove from Los Angles to Las Vegas today, and I'll be darned if it > didn'tmake it just fine! I wonder, though, if I might be better > off not knowing my > oil temperature. In sunny but mild LA, I never got the thing to > read above > 200degF/95degC of so, even diving full-bore, 80mph up short but > fairly steep > grades; But today driving out of Baker, CA in 109 degree heat up > that long, > long grade I was seeing oil temps a hair over the 220F/105C. Oil > pressurewas hovering around 20psi though, so no problem there I > reckon. The oil temp > made me twitchy of course, but only because the only thing I know > is that > it's "higher than it's ever been before". So long as I'm seeing > good oil > pressure, is temperature not a big deal? Is there a temperature > one should > stay under? If all I had was the water temp gauge and oil > blinkenlight, I > would never have known any of this. I'm I suffering paranoia > because I know > too much? > > -- > John Bange > '90 Vanagon - "Geldsauger" >
Have something to add on this topic today? Revive this thread in the forum »