Chris...seen it once when the slave cyl was extended full length due to a
crosshaft failure.
Saw it again once when I used the incorrect diesel lever on a gas
syncro..same result..solid pedal as the slave couldn't move any further...
Daryl of AA Trans
----- Original Message -----
From: "Christopher Gronski" <gronski@GMAIL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, July 04, 2006 6:17 AM
Subject: Clutch Pedal Does Not Move

> After putting in my locking differential, replacing the clutch,
> flywheel, brake master, clutch master, clutch slave, and brake
> switches. I drove 400km to Parry Sound for the weekend. The clutch
> worked fine for the trip up and for two days afterwards.
>
> Then overnight, I got in and the clutch pedal won't move. It is not
> spongy, it doesn't sink to the floor (like it would if the line was
> not properly bled) , it is just jammed in place (maybe a half inch of
> play). I had to start it in gear and drive it back shifiting without
> the clutch (which I HATE doing).
>
> Any thoughts?
> Chris
>
> 86 Syncro AdventureWesty
> 87 Syncro PartsVan
>