> I'm about to install the new seal on my luggage rack, and was 
> just wondering if there's anything I should know aside from 
> the obvious.  There are four screws on the front and sides of 
> the rack, four on the back, and I assume I remove them, 
> remove the rack, then pull out the old seal and put on the new one.
> Is there more to it than that?

That depends on whose luggage rack seal you're installing. Mine can be
installed without removing/loosening the luggage rack at all. You can
carefully slip it under the lip, using a non-sharp object to push it
through. However, other vendors sell poptop seal as a luggage rack seal, so
the insulation bulb (intended for the poptop) makes the seal too thick to go
on without removing the luggage rack first. If you are using a bulbed seal,
be sure to notch it at a couple of points on the sides to allow rainwater to
drain into the rain gutter, as otherwise the bulb may trap water between
your luggage rack and your roof.

- Ron Salmon
  The Bus Depot, Inc.
  www.busdepot.com
  (215)  234-VWVW

_____________________________________________
Toll-Free for Orders by PART # :  1-866-BUS-DEPOT