

| Subject: | Re: Drove My Vanagon Today-All Is Not Well |
| From: | Dennis Haynes |
| Date: | Sat, 16 Dec 2006 22:59:35 -0500 |
Sounds like two of the ignition wires are crossed or for some reason 1 or more cylinders are not firing. If the cat was good, it is not anymore. Dennis -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jeff Stewart Sent: Saturday, December 16, 2006 6:10 PM To: vanagon@GERRY.VANAGON.COM Subject: Drove My Vanagon Today-All Is Not Well Finally got tags for my '84 Vanagon today from the Virginia DMV, luckily using the PO's emission certification. Slapped my tags on and took it for a test drive (first time since putting in a 2.1 running 1.9 FI). At first, it had no power, struggled to get to 30 MPH. No hesitation, no stumbling, just no power. After about 10 minutes though, it seemed to pick up on the power, acceleration was about what I'd consider normal. Luckily I needed gas, so I pulled into a gas station. I noticed what looked like a bit of smoke coming from the engine, which didn't surprise me too much since I had painted the exhaust pipes. However, on checking it out just to be sure, I found the heat shield above the muffler EXTREMELY hot. So hot, in fact, that the wiring that runs across the back of the engine compartment was also hot to the touch and getting soft-the rubber sleeve was getting soft, that is. The wiring is not touching the shield, I have the clips back in place that hold it along the back panel. But there was so much heat radiating off the shield it was about to melt the wiring. With the low power and excessive heat, I'm thinking plugged up catalytic converter-agree? Disagree? Any thought would be appreciated. Jeff Jeff Stewart fonman4277@earthlink.net http://autos.groups.yahoo.com/group/vwcampersmidatlantic/
Have something to add on this topic today? Revive this thread in the forum »