folks, i just replaced my brake master cylinder. i
have done about 30 of these in my life and have never
had issues like this one. It seems there is bubble in
the MC and just won't go away. when you press the
brake  you can hear a sweek, like fluid or passing a
seal or a bubble.
This is a NEW ATE Master cylinder.

I bench bled it prior to install and then bled it with
a pressure bleeder and then had my wife pump the
brakes while i bled it again. The bus stups but not
till the pedal is almost at the floor.

Ideas? would rather NOT take it off and put on another
new one....

Thanks
mp

"may the four winds blow you safely home"

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com