Did you actually measure the propane system pressure coming from the
regulator? Until you do so you are just messing around. Set the pressure
to between 10.5 and 11" of water. Make sure the system pressure is good
even when the stove burners are on. Once the pressure is known to be
right you can proceed to fixing the fridge if needed.

Mark

Michael Diehr wrote:
> Update 2 -- To recap, my fridge has been working poorly -- visible
> red/yellow portion of the flame in the viewing glass, not cooling
> much, and flame going out sometimes.   I pulled it out, cleaned out
> the combustion chamber, and found some gunk in the propane jet nozzle
> thingy.    After reinstalling, the fridge seems to run better, and
> the flame is now a consistent blue.   However, the flame would keep
> going out at night when it was cold.    Also, the stove burners tend
> to also go out when set on low.
>
> Since my van had a new regulator (Marshal 290?) a few years ago, I
> think the data points to low LPG pressure.
>
> I adjusted the regulator to give higher pressure, and things seems to
> have improved -- the stove burners don't blow out easily when on low,
> and the fridge stayed lit for hours.
>
> However, again last night, the fridge flame went out.  Temperature
> was in the low 40s again.
>
> Question --  I'm nearly to the end of the adjustment range on the LPG
> regulator, so I don't think I can get much more pressure.   Is there
> any way on the Dometic to turn up the overall flame level?
> Basically, it seems that what is happening is that High is more like
> Low, and Low is more like OFF -- so that at night it's just going out
> altogether when everything gets cold.
>
>
>