Hi everyone,
  I am new to the list so please be gentle.  Brien Dews was nice enough
to send a post yesterday on my behalf.  I believe I have gotten to the
root of the problem but I need some reassurance.
The Problem(s):
When I turn the key I have no fuel pump and the fuel pump relay does not
engage. It will crank with no effort but with no fuel, no fire.  If I
ground out pin 86 on the F.P. relay it activates the F.P. until I remove
the ground.  I have power to pin 30 and 85 onboth the F.P. and ECU
relays.  If I ground out pin 86 on the ECU relay nothing happens.  I did
try a different relay with the same results.  Next I verified that the
dedicated ground to the ECU relay was in fact grounded and it is. (how)
I reversed my 12v probe and used the clip end to probe while holding the
pointed probe through the wire sheath. It did work as a ground while
testing the relay circuits for power.

Next I removed the ECU relay and used a jumper wire to apply direct
power from pin 30 to pin 87 in the relay connector socket.  I did verify
that power was leaving out the white wire on the back of the socket and
that the ECU in fact was receiving power on the ECU connector.  Turn the
key, same results.  Nothing.   My guess would be that my ECU has taken a
dump.  Any other suggestions or sage wisdom would be greatly helpful.

Thank you,
Billy Hirt Jr.
Buses by the Beach.com