Hi David,
thanks a lot. Does the thin one has the additional holes (additional to
the four 8mm holes in the corner)? If I recall right, at least I think I
used this one between cover and pump.
And the one with only the holes for the stats between case and pump ...
Might be that i am wrong ...
Anyway thanks a lot and take it easy.
Cheers
Thomas

David Kao wrote:
> --- Thomas Pfrommer <pfrommer@PHAS.UBC.CA> wrote:
>
>
>> Hm do you or anyone know the thickness of these gaskets...
>>
>
> Thomas, I just measured the pair of gasket in my Elring set. The thin one
> is about .006" - .007" and the thick one is .02". The thin one was not torn
> apart by merely looking at it though. My computer printer paper of 24 lbs
> is about .003" - .004" You can make one out a sheet paper of 28 lbs or simply
> out a sheet of 24 lbs.
>
> Well, since I have been considered Not Reasonably Conscious for what I do so
> take these numbers at your own risk. I know someone will jump out to cry
> bloody murder because I said these.
>
> David
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>