Thomas, yes, the thin one has four additional small holes, one on each
side of the gasket. The large 4 holes are on the corners. The small ones
(2mm diameter) are on the sides.

The thick one has only 4 large holes on the 4 corners.

David

--- Thomas Pfrommer <pfrommer@phas.ubc.ca> wrote:

> Hi David,
> thanks a lot. Does the thin one has the additional holes (additional to
> the four 8mm holes in the corner)? If I recall right, at least I think I
> used this one between cover and pump.
> And the one with only the holes for the stats between case and pump ...
> Might be that i am wrong ...
> Anyway thanks a lot and take it easy.
> Cheers
> Thomas
>
> David Kao wrote:
> > --- Thomas Pfrommer <pfrommer@PHAS.UBC.CA> wrote:
> >
> >
> >> Hm do you or anyone know the thickness of these gaskets...
> >>
> >
> > Thomas, I just measured the pair of gasket in my Elring set. The thin one
> > is about .006" - .007" and the thick one is .02". The thin one was not torn
> > apart by merely looking at it though. My computer printer paper of 24 lbs
> > is about .003" - .004" You can make one out a sheet paper of 28 lbs or simply
> > out a sheet of 24 lbs.
> >
> > Well, since I have been considered Not Reasonably Conscious for what I do so
> > take these numbers at your own risk. I know someone will jump out to cry
> > bloody murder because I said these.
> >
> > David
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam?  Yahoo! Mail has the best spam protection around
> > http://mail.yahoo.com
> >
>
>

____________________________________________________________________________________
Bored stiff? Loosen up...
Download and play hundreds of games for free on Yahoo! Games.
http://games.yahoo.com/games/front