Hey, this as NOTHING to do with the clutch itself!

Mark is about right.

Your problem is between the master and the release arm/shaft/fork, so how is
that realease arm? (is the shaft and forks that push the release bearing
called "release arm"????), if yes, is this one turning smoothly????, is it
worned out behind repare??? is the slave doing is job? is the master good???

Ben

On Sun, 10 Jun 2007 14:33:12 +0200, Jens Jakob Andersen <jayjay@ZORCK.DK> wrote:

>Hi
>
>More info.
>
>Problem is that slave-cylinder extends fully, and still doesnt push
>enough on relasearm that drives releaseshaft.
>
>Can be several things:
>1. Worn releaseshaft - fingers worn out, cant push releasebearing enough
>2. Worn releaseshaft bushings, uses energy topush releaseshaft
>instead of turning it?
>3. Problem with the flywheel?
>4. Problem with the clutch?
>
>Any other ideas?
>
>I will try to find a way to add a spacer inside the internal dome of
>the piston of the slave, so it can push further on the releasearm on
>the gearbox.
>
>Best regards
>
>Jens Jakob