--- Matt Roberds <mattroberds@COX.NET> wrote:

> We figure that the ones on the case end of the cylinders are probably just
> as beat up.  Is there any good way to install these without pulling the
> cylinders?

> I figured on doing something like bringing a piston to TDC, pulling the
> cylinder out as far as possible without losing the rings, and then
> rolling the O-ring down from the top.  Then, seat that cylinder in the
> case, bring the other piston to TDC, and repeat.  Or is this a recipe
> for problems later?

Matt, that's what I did for one of my cylinders. The o-ring for the bottom
of the cylinder is like a rubber band. Just do it carefully and not to
break it. It has worked fine on my engine for over 1500 miles since the rebuild.

David

____________________________________________________________________________________Ready for the edge of your seat?
Check out tonight's top picks on Yahoo! TV.
http://tv.yahoo.com/