John,

I have had this problem before and I cut the end of the throw out
bearing actuator shaft off at the place where it enters the bellhousing
with a sawzall and then pressed the remainder of it out of the center of
the clutch lever with a hydraulic press!  Then I had to install a new
clutch actuator shaft into the bell housing.  That bugger came apart but
it wasn't pretty :-(

I have the actuator shafts in stock if you find you need one.

Ken Wilford
John 3:16
www.vanagain.com
John C... wrote:

>Cant get that bugger off !!!???!!!
>(yes, removed the C-clip  :o)
>Pulled it, beat it, heated it, filed a chamfer.
>It will move back & forth about 1/32nd inch.
>What th' Heck !!!
>Anything else holding that bugger on there???
>Gotta get the tranny ready for vacation !!! :o)
>Thanks,
>John C...
>
>
>