I know this has been answered many times on the Yahoo group, but I
cannot reach that page due to my main computer crashing (text-based
laptop is my only computer at the moment) ~so~

I am fully aware that I will need to do some drilling, and I am able to do that.
One thing however, that bothered me is that I had to do some massaging
of the passenger side engine mount (to clear the thermostat housing).
Also, when using the existing holes in the frame (rear holes) do not
line up whatsoever with any of the stock mount holes (Even when the
mount is flipped backwards) Is the best course of action to drill new
holes in the crossmember?
Thanks in advance for not telling me to rtfm, or something along those lines. :D

Sudhir