--- Scott Daniel - Shazam <scottdaniel@TURBOVANS.COM> wrote:

> Hi.
> Since you have so much concern about wear on initial start up,
> Maybe you should have a pre-oiler device on your engine...
> With this system you can provide oil pressure to the bearings, before even
> cranking the engine.
> Scott
> www.turbovans.com

Scott, thanks for the suggestion. my concern is really the first few miles
of driving when oil is not fully warmed up and the viscosity is still high
which makes it flow slower than desired to replenish the thin oil film
scraped off by the extreme pressure between metal surfaces, such as inside
a crankshaft bearing.

I am wondering if it makes somewhat significant difference between a 5w-xx
oil and a 20w-xx oil, especially in winter. Pre-oiler addresses the dry
running issue upon initial starting up. But it does not address the issue
of oil before warming up.

My concern may be answered already by many who have said no problems. When I
rebuilt my 83.5 engine two months ago at 110k miles I saw no problems in the
bottom block. I wonder if I need to pay more attention to oil so that when I
need to rebuild it again say at 200k miles I could get away without align
borning for the crank.

Hope this makes sense, (or not). I will probably toss the block if it needs
major work such as align borning. I may be opening another can of worms by
saying this. Basically labor cost in the SF Bay Area is so high that I would
rather find a way to prevent it from becoming necessary too soon.

David

____________________________________________________________________________________
Moody friends. Drama queens. Your life? Nope! - their life, your story. Play Sims Stories at Yahoo! Games.
http://sims.yahoo.com/