Yes, both lower studs are 97mm M10 for a manual tranny waterboxer case.
I just measured one to be sure.

Mark

Christopher Gronski wrote:

> So that's 2 studs at 97mm each right?
>
> On 10/23/07, *Mark Drillock* <drillock@earthlink.net
> <mailto:drillock@earthlink.net>> wrote:
>
>     The short one listed is 76mm so the 97mm should be right.
>
>     Mark
>
>     Bob Donalds wrote:
>
>      > the automatic stud is shorter than the std trany stud
>      > 97 MM sounds short
>      > Bob
>      >
>      >
>      > ----- Original Message -----
>      > From: "Old Volks Home" <oldvolkshome@GMAIL.COM
>     <mailto:oldvolkshome@GMAIL.COM>>
>      > To: < vanagon@GERRY.VANAGON.COM <mailto:vanagon@GERRY.VANAGON.COM>>
>      > Sent: Tuesday, October 23, 2007 9:43 AM
>      > Subject: Re: Need the two lower studs that secure the
>     transmission to the
>      > engine - No P# in ETKA
>      >
>      >
>      >> Chris -
>      >>
>      >> Actually, these should be studs:
>      >> VW # N0146752 - 10 x 97mm
>      >> Illustration 3-10, Key #43
>      >
>
>