Great and is there any dispute on the part number? I found this at
GermanSuppy that looks right:

http://www.germansupply.com/home/customer/product.php?productid=16855<http://www.germansupply.com/home/image.php?productid=16855>

Chris

On 10/23/07, Mark Drillock <drillock@earthlink.net> wrote:
>
> Yes, both lower studs are 97mm M10 for a manual tranny waterboxer case.
> I just measured one to be sure.
>
> Mark
>
> Christopher Gronski wrote:
>
> > So that's 2 studs at 97mm each right?
> >
> > On 10/23/07, *Mark Drillock* <drillock@earthlink.net
> > <mailto:drillock@earthlink.net>> wrote:
> >
> >     The short one listed is 76mm so the 97mm should be right.
> >
> >     Mark
> >
> >     Bob Donalds wrote:
> >
> >      > the automatic stud is shorter than the std trany stud
> >      > 97 MM sounds short
> >      > Bob
> >      >
> >      >
> >      > ----- Original Message -----
> >      > From: "Old Volks Home" <oldvolkshome@GMAIL.COM
> >     <mailto:oldvolkshome@GMAIL.COM>>
> >      > To: < vanagon@GERRY.VANAGON.COM <mailto:vanagon@GERRY.VANAGON.COM
> >>
> >      > Sent: Tuesday, October 23, 2007 9:43 AM
> >      > Subject: Re: Need the two lower studs that secure the
> >     transmission to the
> >      > engine - No P# in ETKA
> >      >
> >      >
> >      >> Chris -
> >      >>
> >      >> Actually, these should be studs:
> >      >> VW # N0146752 - 10 x 97mm
> >      >> Illustration 3-10, Key #43
> >      >
> >
> >
>