Really, Ken? How much ground clearance does that leave, about two inches
max? And the tranny mount? Please tell us you're just messing with us.

Ken Wilford wrote:
> We did this mod for a customer.  Basically you have to lower the engine
> by about 6 inches to get it to fit.  We did this by welding steel "L"
> plates onto the engine carrier bars.
> Here is how we did it:
> We then installed some liquid filled mounts from a Jetta onto the bottom
> of the alloy engine mounts.  Then install your "L shaped brackets to the
> bottom.  Now use the jack that has been supporting your motor this whole
> time and lower the engine to the desired height.  Make some tack welds.
> Support the engine again and remove the carrier bars.  Weld stuff up
> right.  Replace carrier bars and you should be good to go.
> //:::::::::::::::::::::::::::
> :::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
>
> :::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
>
>> Is it possible to put an ABA 2.0L at 15 degrees in a Westy without
>> modifying the lid?
>> Best regards.
>> Gilles Turmel
>>
>>
>>
>
>