You need Robert Keezer, he's The Gas Heater Man!

Not far away either, near Seattle.

On Dec 9, 2007 4:16 PM, Courtney Hook <courtneyhook@shaw.ca> wrote:

> OK, I've got two B2 Eber. gas heaters here, and the thermoswitch/quarz
> sensor rods are NOT coming out without shearing the top off the inner
> chamber threaded connection, (in fact I've already done this with one, so I
> suspect the heater is instant junk). They are SO delicate here, yet it
> requires their removal to service the switch. VERY poor design. After 30
> yrs, the nuts are so siezed on I would say your are NOT going to get them
> seperated from the inner chamber threaded male fitting. If anyone knows who
> can service and hopefully repair my little learning experience I would
> appreciate it.
> Thanks,
> Courtney
>

--
Jake
1984 Vanagon GL
1986 Westy Weekender "Dixie"
Crescent Beach, BC
www.crescentbeachguitar.com
http://subyjake.googlepages.com/