Allan,

I find that the non-metric is close enough for most applications.  And I get
my copper crush washers "cheap" at Harbor Freight
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93324

Jack

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Allan Streib
Sent: Thursday, December 27, 2007 10:14 AM
To: vanagon@GERRY.VANAGON.COM
Subject: seeking source for copper crush washers

I need an M14 and M16 sized copper crush washer to reconnect the low
and high side fittings on my new power steering rack.  The one web
site I found that lists them does not process orders for less than
$25.

Anyone know a good place to get these?  I've tried local hardware and
a few auto parts stores.  Will check NAPA today but not holding out a
lot of hope based on results elsewhere.

Allan
--
'91 Vanagon GL