

| Subject: | Re: Foam rubber source for bench seat |
| From: | Jonce Fancher |
| Date: | Thu, 3 Jan 2008 20:07:36 -0500 |
Hi Troy There is another option since you have the memory foam. You could have it Slit. so take 1 inch of Memory foam and and it to instead of 4 inch foam to 3 inch foam. Then just stack the 1" Memory on the 3 inch 2535. You will have a good base and a wonderful topper built in to the cushion for sleeping. Best of both worlds. Also since your purchasing an inch less it will be cheaper. Hope this helps. Good luck. Jonce >Hi Jonce: >I was originally going to use memory foam; in fact, I bought a full-size >mattress, which wasn't cheap. After getting the rear seat covered I >discovered that this memory foam compresses way too much, and takes a long >while to get back to its original shape. Very comfortable to sleep on, but >not so good for sitting. I mention that, as we had spoken once before about >this, and the fabric. I ended up getting the fabric from Sew Fine-- great >folks to deal with, and they had some fabric that matches the original >pretty close. >Thanks for the information about the quality of the foam. The stuff this >shop sells is 2535, so sounds like good stuff. I guess I'll bite the bullet >and spend the $200--yikes. >Troy > ----- Original Message ----- >From: "Jonce Fancher" <streetbugs@whispllc.com> >To: "vanagon" <vanagon@gerry.vanagon.com>; "Troy" <colorworks@gci.net> >Sent: Thursday, January 03, 2008 3:15 PM >Subject: Re: Foam rubber source for bench seat >> Hi Troy >> I could sell you foam but shipping is just Too much!!!! >> The issue with foam is it is a Petroleum product and has increased in >> cost/Price as much as fuel prices. Also foam is sold by the Board Foot >> 12x12x1. The >> issue you will have to pay for the Scrap as well as the foam you will use. >> Now if all you need is the seat Bottom it shouldnt be all that bad but >> once you add the back and the rear cushion it is not unheard of to tap >> into 200 bones >> for a good pc of foam. The better the quality of foam the more it will >> cost. Also the better the quality the Longer it will last. For the Rear >> seat I would >> recommend a Minimum of 2235 >> The 1st two numbers ( 22) is the quality. High density starts at 1.8 foam >> or 18. This is better then what your sofa cushions are when new and will >> last longer. >> You can also go up to 3.0 but it gets fairly pricey. >> The 2nd two numbers ( 35 ) is the Firmness. 35 is a good medium foam that >> will feel good to sleep on and sit on unless your over 220 pounds then go >> to >> 2240 or 2245 same quality and price but firmer. >> If it is firmer it does not cost More!! ONLY quality will make it cost >> more. >> Hope this helps or it may confuse you more but ask them if they but from a >> cutter or a supplier. If it is coming from a supplier you will be paying >> the suppliers >> markup. The Cutter will sometimes be cheaper but you can get more of a >> selection of sizes. standard sizes are 24 inches wide BUT a Cutter will >> usually cut >> a BUN and can cut 72 inch by 84 inch by 60 inches and slice it down to >> what you need. so you can get a wider sheet and less waist. which is what >> you >> want since the more you waist the less you get but you still pay for it >> all. >> C-ya Jonce >> As for pricing I would not have any idea what that zone has to offer. Try >> the net or internet yellow pages. Also shipping is expensive so make sure >> you factor >> that in before you buy. >> Jonce >> >>>Hi folks: >> >>>Was just quoted nearly $200.00 for the rear bench seat (foam only) for my >>>89 Westy, which seems very high to me. Anyone know of a source for foam in >> the pacific northwest? I'm actually in Alaska, but Washington or Oregon >> will probably be my closest source. >> >>>Thanks, >> >>>Troy >> >> >> Jonce Fancher >> >> 56 Single Cab >> 66 Sunroof Bug >> 66 Variant Squareback >> 66 Porsche 912 >> 71 Sunroof Bus >> 84 Vanagon "Gottfried" >> 85 Vanagon Westi >> 2003 10 Passenger Sprinter >> >> Fancher's Upholstery Inc. - www.fanchers.com >> Not-A-VW Club- http://mywebpages.comcast.net/jaransont3/notavwclub/ >> >> >>. Jonce Fancher 56 Single Cab 66 Sunroof Bug 66 Variant Squareback 66 Porsche 912 71 Sunroof Bus 84 Vanagon "Gottfried" 85 Vanagon Westi 2003 10 Passenger Sprinter Fancher's Upholstery Inc. - www.fanchers.com Not-A-VW Club- http://mywebpages.comcast.net/jaransont3/notavwclub/
Have something to add on this topic today? Revive this thread in the forum »