I just got an 86' syncro and a totaled 86' westy.  I would like to put the westy cabinets and curtian rails into the syncro.  I have searched the archives but still have a few questions.
 
I will try to be as clear as possible.
 
NOTE: I am not going to transfer the pop-top to this van, it will be transfered to another van.
  
(I am going to go the easy route and only cut the hole were the sun roof would be.  My goal is to have standing and storage room, not to make another bed.)
 
1. I assume the rear clothes closet will fit without any problems since the roof is higher in a non-westy due to its curvature.  Is this a correct assumption?
 
2. For mounting the cabinets I plan to just use the original sheet metal screws but I am concerned about the front bracket of the rear clothes closet, since the syncro gas tank is underneath where the bracket is secured.  Is there enough clearence to just use the origninal sheet metal screws?
 
3. Also the rear seat brackets are screwed into welded on metal tabs that I do not want to transfer over.  I would like to just use sheet metal screws but again I am concerned about the clearence of the syncro gas tank.  (I am talking about the ones behind the seat, the ones inside the seat should not interfer with the gas tank)
 
4. What about the curtian rails?  How can I mount them without the hole for the poptop?
 
5. Can I transfer the westy floor to the syncro?
 
6. How do I remove the swivel seats?  Are they welded on?
 
 
Thanks,
David Hines
 
_________________________________________________________________
Helping your favorite cause is as easy as instant messaging.�You IM, we give.
http://im.live.com/Messenger/IM/Home/?source=text_hotmail_join