Thanks Scott.

Yah I'm not certain the kit contains all the correct parts.

The "Center shift rod bushing" that's in my Vanagon currently works.
Just thought I'd pop in a new one while gas tank is out.

I'll lube it up, leave it in, and wait until I have to do the
crossover lines again. Like in more than several years I hope!

In the meantime, I'll order a kit from an actual Vanagon vendor that
sells a kit with *all* the right parts.

Thanks,

Neil.

On Mon, Feb 25, 2008 at 2:51 PM, Scott Daniel - Shazam
<scottdaniel@turbovans.com> wrote:
> Most likely it should say 1980 to 82.
>
>  The support bushing above the approximate middle of your fuel tank is not
>  fitted  in  83 and up vanagons.
>  The support bushing those use is   bolted to a 'frame member' at the aft
>  edge of the fuel tank.
>  Scott
>  Turbovans
>
>
>
>  -----Original Message-----
>  From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
>  neil N
>  Sent: Monday, February 25, 2008 11:07 AM
>  To: vanagon@GERRY.VANAGON.COM
>  Subject: California Imports Bus Shift Rod Bushing Kit?
>
>  Hi all.
>
>  Anyone used this kit with success?
>
>  http://www.cip1.ca/ProductDetails.asp?ProductCode=VWC%2D211%2D711%2D211
>
>  I've pretty much confirmed there is a typo, but this kit says: 90-92
>  Vanagon. Likely should read "80-92".
>
>  I'm replacing the center shift rod bushing on my '81 air cooled.
>
>  Thanks,
>
>  Neil.
>
>  --
>  Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco"
>
>  http://web.mac.com/tubaneil
>  http://tubaneil.googlepages.com/
>
>

--
Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco"

http://web.mac.com/tubaneil
http://tubaneil.googlepages.com/