I did the same/similar procedure when I got my 83 diesel westy. It had been
hit and had that main left-side panel replaced with a non-westy piece welded
in. The fridge vent hole was there, but not the three utility holes. I had
nothing but gowesty replacements to go by, but it only took a few minutes to
create a template after looking at enough pictures online to see how the
placement went. Covered the area with tape, spray glued the template over
that, and sawed away.
Jim

On Sun, May 18, 2008 at 8:58 AM, John C... <Trvlr2001@comcast.net> wrote:

> Hi Mark,
> Thanks for the reply!
> Found this pic on line, &
> I am looking for his web page on this Pop Top Conversion.
> Although a picture does say a K words,
> Wish I had a little dialog on his procedure.
> Thanks again,
> John...
> PS: Nice House ! :o)
> -------------- Original message --------------
> From: mdrillock <mdrillock@COX.NET>
>
> > That is not me but it is my driveway and I took the photo. The guy with
> > the saw is a list member and a friend of mine.
> >
> > Mark
> >
> >
> > John C... wrote:
> > >
> >
> http://www.kodakgallery.com/I.jsp?c=wua8um1.jyg6jhh&x=0&h=1&y=-okz5yp&localeid=e
> > n_US
> > >
> > >
>