I'm unsure if I am or not.  Have noticed the PT doesn't seat completely
(stays about 1/2" high on the FR corner) if I have the bed completely
extended.  If I fold the front rearward via the hinge it does and the front
seal doesn't allow air/rain inside the top/front edge seal.  I also noticed
the same section isn't 'square' when extended fully but barely has enough of
the utility side edge to sit on the ledge support.  I've not noticed any
wear as described by you but will inspect and advise if so.

On Fri, Jun 6, 2008 at 3:22 PM, Mark Tuovinen <mst@ak.net> wrote:

> Our `87 Westy Syncro's top bunk hinge is rubbing the inside of the top
> enough to gouge the top.  This is happening with the top down and the bed
> stowed.  The offending piece is part of the hinge for the bed.  When the bed
> is stowed for travel it is pushed to the rear as far as it will go, but it
> shifts forward and comes in contact with the top.
> Is anyone else having this issue and/or does anyone have a solution for it?
> TIA,
> Mark in AK
>

--
Neil
'82 Diesel Westy
Peace of